wiki:Internal/WinlabMadwifi/RateControl

wiki:Internal/WinlabMadwifi -> Introduction to Rate Control

Rate Control

General Information could be found in this link.

Rate control, or rate adaptation, is a technique to adapt PHY channel rate in sender node. With the help of either some explicit feedback from recever (ACK frames) or implicit information (RSSI), the sender infers channel quality and choose a proper modulation scheme for next outgoing packet to maintain acceptable BER/PER/Throughput performance.

Files involved for rate control:

  • ath/if_ath.c
  • ath/if_athrate.h
  • ath_rate/amrr/amrr.h
  • ath_rate/amrr/amrr.c
  • ath_rate/onoe/onoe.h
  • ath_rate/onoe/onoe.c
  • ath_rate/sample/sample.h
  • ath_rate/sample/sample.c

Main interfaces in if_ath.c

When the rate is determined?

when a packet is xmitted, a rate has to be determined associate with this packet. This is done in the ath_tx_start(struct net_device *dev, struct ieee80211_node *ni, struct ath_buf *bf, struct sk_buff *skb) function. A call to ath_rate_findrate will fill the pointer to txrate and this rate will be passed into tx-descriptor.

      if (ic->ic_fixed_rate == -1) {
               / * Data frames; consult the rate control module.
                 */
              ath_rate_findrate(sc, an, shortPreamble, pktlen,
                                 &rix, &try0, &txrate);
       }
       else {
                  rix = ic->ic_fixed_rate;
                  try0 = ATH_TXMAXTRY; //XXX: should be configuralbe
                  if (shortPreamble)
                        txrate = rt->info[rix].shortPreamble;
                  else
                        txrate = rt->info[rix].rateCode;
      }

When statistics are collected?

After the packet is transmitted, function ath_tx_processq(struct ath_softc *sc, struct ath_txq *txq) is executed. In this function, ath_rate_tx_complete will be called.

   sr = ds->ds_txstat.ts_shortretry;
   lr = ds->ds_txstat.ts_longretry;
   sc->sc_stats.ast_tx_shortretry += sr;
   sc->sc_stats.ast_tx_longretry += lr;
   /*
    * Hand the descriptor to the rate control algorithm.
    */
    if ((ds->ds_txstat.ts_status & HAL_TXERR_FILT) == 0 &&
    (bf->bf_flags & HAL_TXDESC_NOACK) == 0)
             ath_rate_tx_complete(sc, an, ds);

sc contains updated statistics and will be read by rate control module.

Rate-control modules

Function: ath_rate_findrate

This function takes following parameters:

  • struct ath_softc * sc :local priv in driver
  • struct ath_node * an : Destination Node
  • int shortPreamble,
  • size_t frameLen : used by SampleRate algorithm to calculate throughput for a certain packet length bin.
  • u_int8_t *rix,
  • int *try0 : return to show how many attempts should be used for this txrate.
  • u_int8_t *txrate : return the transmit rate.

Last modified 13 years ago Last modified on 08/25/06 21:24:36