| Version 72 (modified by , 11 years ago) ( diff ) |
|---|
Tutorial TOC
ORBIT Tutorials
1. Basic Tutorial
1.2 Tutorials on controlling the testbed nodes
- How to load (install) a disk image on a set of nodes
- How to save an existing disk image from one node
- How to query the status of a set of nodes
- How to switch On/Off a set of nodes
1.1 Introductory Expirments
This section gives an introduction to the ORBIT testbed, its capabilities and its operations. It also presents the basic knowledge required to write and execute experiments for the testbed.
If you are new to the ORBIT testbeds, reading and running the tutorial in this section should help you getting started.
The first part of this tutorial briefly describes the ORBIT Testbed, its system architecture and its hardware and software components. The second part presents and describes a simple "Hello World" experiment with one sender and one receiver. The third and concluding part covers the collection an interpretation of measurements and results of an experiments on the ORBIT testbed.
- Brief tour of the Testbed
- First Experiment: the "Hello World" Example
- How measurements are collected
- How to post-process these measurements
2. Additional refrences
After completing the above basic tutorial, you should have a better understanding of using the ORBIT testbed to experiment your ideas, algorithms, or protocols. The tutorials in this second section further explore the various ORBIT functions that will help you write and execute more advanced experiments.
Finally, some more detailed information and references can be found on the Documentation page
Gnu Radio
- Tutorial: Getting Started with GNURadio
- Tutorial: Observing the Spectrum with GNURadio
- Tutorial: MAC protocols adaption
More documentation on the GNURadio can be found here
WiMAX Reference
The WiMAX resource center can be found at http://wimax.orbit-lab.org.
Further Documentation
The OMF project has further documentation at http://mytestbed.net/projects/omf.
