Changes between Version 21 and Version 22 of Old/Hardware/hNodes/cNodeVer3/dAssembly/bCM


Ignore:
Timestamp:
Jan 10, 2013, 11:23:12 PM (12 years ago)
Author:
Ilya Chigirev
Comment:

Legend:

Unmodified
Added
Removed
Modified
  • Old/Hardware/hNodes/cNodeVer3/dAssembly/bCM

    v21 v22  
    11[[TOC(Hardware/fAssembly, Hardware/fAssembly/CM*, depth=4)]]
    22===== CM Installation =====
    3 ====== Wiring ======
     3''' Wiring '''
    44  1. Attach the red and black power connector wires using the vampire clips to the purple and any black of the 24 pin ATX power supply connector respectively. See image below[[BR]][[Image(VampClip.jpg, 300)]].
    55  2. connect the red/black twisted pair cable to the motherboard, and the other end to the CM as shown in the pictures below. Do the same for the blue/black twisted wire pair. The header on the MB is next to the RAM and SATA connectors. [[BR]][[Image(CmWire.jpg, 300)]] [[Image(CmWireMotherB.jpg, 300)]]
    66
    7 ====== Mounting ======
     7''' Mounting ''
    88[[BR]][[Image(CmMount.jpg, 300)]]
    99  1. Attach the 3 6-32 hex stand offs to the cm card with the 3 6-32 pan head screws. the stand offs should be on the non-component side of the CM
     
    1212  4. thread the other end of the flat serial cable (The other side should be going through slit on top of the face plate) in between the standoffs as to keep it in place and above the fan, them use the 3 3/16" 100 degree screws to attach the cm to the U chassis.
    1313
    14 ====== Flashing ======
     14''' Flashing '''
    1515Full instructions for flashing the CM3 can be found [http://www.orbit-lab.org/wiki/Hardware/cCM/cCM3/02-SoftwareDescription#FlashingFirmware here].