Changes between Initial Version and Version 1 of Internal/NoiseGenerator/Hardware/WiBo


Ignore:
Timestamp:
Jan 6, 2007, 11:06:40 PM (18 years ago)
Author:
anonymous
Comment:

Legend:

Unmodified
Added
Removed
Modified
  • Internal/NoiseGenerator/Hardware/WiBo

    v1 v1  
     1== Orbit Noise Generator Wireless Board (WiBo) ==
     2
     3WiBo102 is a 4.00 x 4.00” printed circuit board (PCB) designed around a Maxim, Inc. MAX2829ETN+D radio transceiver chip. This chip incorporates most of the radio functions except for the reference oscillator, baseband I/Q amps, power amps and antenna switches.
     4
     5Four antennas (A01-A04) are mounted directly to WiBo102 though provision is made for adding SMA connectors and using off-board antennas if necessary.  Two antennas are primarily for transmission (Tx) and two for receiving (Rx).  Antenna switching is possible for diversity gain.
     6It is also possible to switch all Tx and Rx signals into a single antenna.
     7
     8
     9A.      PCB
     10The PCB is a 4.00 x 4.00” FR-4 four-layer controlled impedance stackup board manufactured by Advanced Circuits, Inc.(http://www.4pcb.com/index.htm). 
     11For orientation purposes, reference marks are shown along the top (A-D) and right sides (1-4) of the board in one inch increments.
     12
     13Looking from the top down, the top copper layer is the component side with all the high-frequency RF transmission lines.  The dielectric under this layer is 20 mils thick. The structure of the traces is coplanar waveguide with ground (CPWG). 
     14A trace width of 30 mils and gap-to-ground of 18 mils provides a very close match to a 50ohm characteristic impedance. 
     15
     16The next copper layer down is all ground plane.  The third layer down is a signal layer with predominately vertical traces surrounded by ground plane.  The fourth or bottom layer is another signal layer with predominately horizontal traces.