Airspan LTE Base Station Serial Console

The Airspan base stations have a 9 pin connector (hidden behind a black hex bolt next to the

ethernet port) which allows access to the two serial consoles (one for the airspan radio and the

other for the networking unit). This is useful for recovery purposes when the base station does not

respond via software, SSH, or web interfaces.

Connector

Compatible connector on Digikey (CUI Inc. model MD-90): [​https://www.digikey.com/product-

detail/en/MD-90/CP-2090-ND/145326 CP-2090-ND]

• Black plastic casing and strain relief are discarded, otherwise it will not fit into the base

station.

• The front ¾" of the connector must be kept clear (even heat shrink tubing on the front section

will prevent insertion).

• Solder wires to the shorter/larger diameter pins.

Pinout of base station "jack" (or the side of the connector you will solder to):

Airspan	TX1, RX1
asil8xx	TX2, RX2
Ground	outer casing

Connect over a standard RS232 serial port.

Serial Port Settings

Baud Rate	120000
Data Bits	8
Stop Bits	1
Parity	none
Flow Control	none
Transmitted Text	append carriage return (not applicable to PuTTY)

Note: PuTTY is recommended because it can properly forward Ctrl+C like commands to the base

station which are necessary because the consoles have a linux shell.