This page explains how to create an image with enabled Bluetooth. == Current images with BT enabled == * bluetooth-0.1.2.ndz built on baseline-1.0.9.nzd with old madwifi and kernel 2.6.12 The reason to keep this is that old madwifi allows to change transmit power. * bluetooth-0.2.0.ndz built on baseline-2.0.ndz with hacked nodeAgent to support new madwifi ToDo: Make version 0.2.1 for which the USB sticks are recognized on boot!!! == Making Bluetooth work == The kernel must have USB and Bluetooth support enabled. If that is not the case: {{{ /usr/src/# make menuconfig }}} To make USB sticks recognized on boot, select: * USB: {{{ Device Drivers ---> USB Support ---> }}} * Bluetooth: {{{ Device Drivers ---> Networking Support ---> Bluetooth Subsystem Support ---> }}} Compile the kernel and reboot. There should be /proc/bus/usb directory created. {{{ apt-get install bluetooth /etc/init.d/bluetooth start }}} After that you should be able to see something like: {{{ node1-1:~# hciconfig hci0: Type: USB BD Address: 00:0A:3A:53:D4:82 ACL MTU: 192:8 SCO MTU: 64:8 UP RUNNING PSCAN ISCAN RX bytes:395 acl:0 sco:0 events:17 errors:0 TX bytes:313 acl:0 sco:0 commands:16 errors:0 }}} In order to save the image, and be able to login to the node by means other than the serial console delete the following file if exists: {{{ node1-1:/etc/udev/rules.d# rm z25_persistent-net.rules }}} Otherwise, saving an image causes the interfaces to "shift" from eth0 and eth1 to eth2 and eth3, and the node is after imaging accessible only through the serial console. == Some usefull links == http://www.gentoo.org/doc/en/bluetooth-guide.xml http://wiki.debian.org/Bluetooth http://www.linux-usb.org/USB-guide/book1.html